Don't Just Turn it Off, Lock It Out!
Any powered equipment is potentially dangerous—even if it’s supposed to be shut down! Many needless accidents occur when somebody turns on a machine that other employees are repairing. "I didn’t know anyone was working on it" is the usual alibi in accident investigations.
Accidents occurring under these circumstances are not only needless but serious. They result not in small cuts or scratches, but most often cause amputations, serious fractures, and death. Any energy source—electrical, mechanical, pneumatic, hydraulic, or gas—can be deadly if not controlled.
There is one sure way to prevent such accidents from happening to you and that is to make certain that power cannot possibly reach machinery while you are adjusting or repairing it. How is this accomplished? By locking out and tagging power at its source. These procedures are so important that there are federal safety regulations covering them.
Locking out means placing a lock on a device that prevents the release of energy, such as an electric circuit breaker, a disconnect switch, a line valve, a block, and others.
Tagout means attaching a tag on a switch or other shutoff device that warns others not to start up the equipment. Tagout may only be used together with lockout, unless locking out the equipment is impossible.
Sounds easy? It is, if procedures are followed correctly. Here is a general lockout procedure that can be adapted to your job.
1. Turn off the equipment at the control panel
2. Turn off or pull the main disconnect
3. Attach your safety lock at the main switch
4. Try to restart the equipment at the control panel
5. Check the machine for possible residual pressures, particularly for hydraulic systems
6. Complete your servicing work
7. Replace all guards on the machinery
8. Remove your safety lock and adapter
9. Let others know that the equipment is back in service.
No lockout system will be effective if it is undertaken in a hit- or-miss fashion. Here are some common mistakes in lockouts.
See how many you’ve been guilty of:
"This job will only take a few minutes. I don’t need to use a lock—I’ll just shut it down."
Your co-worker pulls the switch and correctly locks it out. Then you place your lock through his lock. When he finishes up first, he removes his lock and leaves yours lying on the ground near the switch. Now you have no protection. Always use a multiple lockout when more than one person is servicing the equipment.
You locked out the control circuit and thought that was good enough. Wrong! The main disconnect or switch must be locked out too. Even one drop of water or a few particles of dust can cause a machine to operate without anyone pressing any start buttons.
As you can see, it is up to you, the employee, to perform a proper lockout. Make sure you have received training and understand exactly what to do. Your life may depend on it!
5x5 Review: Review any accidents or near misses that occurred from the past week.